The sender domain has a DMARC Reject/Quarantine policy which disallows sending mailing list messages using the original "From" header.
To mitigate this problem, the original message has been wrapped automatically by the mailing list software.
--- Begin Message ---Hello, On Friday, May 5, 2017 9:19:36 PM CEST Ram Chandra Jangir wrote: > This change add nand boot support for IPQ40xx based > AP-DK04.1-C1 board using ubi image, also add sysupgrage > support for AP-DK04.1-C1 and generates a sysupgrade.tar > image. > > Testing: > *Tested on IPQ40xx AP-DK04.1-C1 and IPQ806x AP148 Board: > a. NAND boot > b. ubi sysupgrade > > Signed-off-by: Ram Chandra Jangir <rjan...@codeaurora.org> Thanks for posting this. Chris Blake is currently in the process of adding the Cisco Meraki MR33. <https://github.com/riptidewave93/LEDE-MR33> The MR33 uses the IPQ4029 and has just a Spansion S34ML01G200TFV00 128MiB NAND Flash for storage. He reported that with this patch attached. The driver is loading, but it can't access the nand: [ 0.860703] nand: second ID read did not match 7f,7f against 01,71 [ 0.861633] nand: No NAND device found The id is supposed to be 01 (manuf = Spanion), f1 (128MiB). both readings are bad. I think this is caused by two problems: 1. 7f, 7f should be 0xff, 0xff. 0x71 should be 0xf1. 2. It seems that the NAND chip was not ready on the first read. I strongly suspect (due to the MSB error for BIT 7), that at least one I/O line is missing due to a bad pinctrl/mux setup. Could you please add the pinctrl nand definitions to the dts so he can test again? Regards, Christian
--- End Message ---
_______________________________________________ Lede-dev mailing list Lede-dev@lists.infradead.org http://lists.infradead.org/mailman/listinfo/lede-dev