The one on the site you linked to is a one start being held and a two start in the machine. It looks like a 1.5" bit he used. Have a look again and let me know what you would like the look to be. Either bit will work just fine.
Mike OK mike wrote: >Hi, >I need to make a 3" dia. barley twist post, is there a formula to >figure out the #of starts, pitch and bit diameter? >I have the 2" and 1 1/2" bit and wasn't sure if these would work or if >I should get a 3" bit. >I would like to do a 2 start like they have on the legacy website the >top picture that somebody is holding. >http://legacywoodworking.com/technique.cfm?techniqueID=2 >I think that is 2" > thanks for your advise, > > Mike >> >------------------------------------------------------------------------ > > >No virus found in this incoming message. >Checked by AVG - http://www.avg.com >Version: 8.0.173 / Virus Database: 270.8.0/1717 - Release Date: 10/9/2008 4:56 >PM > > > --~--~---------~--~----~------------~-------~--~----~ You received this message because you are subscribed to the Google Groups "Legacy Ornamental Mills" group. To post to this group, send email to Legacy-Ornamental-Mills@googlegroups.com To unsubscribe from this group, send email to [EMAIL PROTECTED] For more options, visit this group at http://groups.google.com/group/Legacy-Ornamental-Mills -~----------~----~----~----~------~----~------~--~---