yes it is my carbide tip insert cutter it has 3 small tips instead of the
larger flat surface of a legacy planing bit which makes it better for light I
repeat light cuts in only soft metals like aluminum its not too bad on the
wood too which is what the cutter id made for.
Bill
----- Original Message -----
From: curt george
To: legacy-ornamental-mills@googlegroups.com
Sent: Thursday, May 24, 2012 11:27 AM
Subject: Re: some thing differant
Bill
Are you using carbide router bits to cut this? or are you using end mill bit?
I've been told that the carbide made for wood is not the same carbide used
for end mills and other tool steel (cutting equipment.).
Good job on this projects of yours. Just be careful, nether the Legacy or
most router bits are up to metal cutting standards,Safety first.
Thank you for sharing.
C.A.G.
----- Original Message -----
From: Bill Bulkeley
To: legacy-ornamental-mills@googlegroups.com
Sent: Wednesday, May 23, 2012 6:28 PM
Subject: some thing differant
I neede a slid for my saw bench so i made one from aluminium I planed it on
the legacy and cut it to lenth on the saw bench with a metal blade
but just to show it milled ok on the 900 slowest speed on the router and
cuts no bigger than 0.020"
Bill
--
You received this message because you are subscribed to the Google Groups
"Legacy Ornamental Mills" group.
To post to this group, send email to
legacy-ornamental-mills@googlegroups.com.
To unsubscribe from this group, send email to
legacy-ornamental-mills+unsubscr...@googlegroups.com.
For more options, visit this group at
http://groups.google.com/group/legacy-ornamental-mills?hl=en.
No virus found in this message.
Checked by AVG - www.avg.com
Version: 2012.0.2176 / Virus Database: 2425/5018 - Release Date: 05/23/12
--
You received this message because you are subscribed to the Google Groups
"Legacy Ornamental Mills" group.
To post to this group, send email to legacy-ornamental-mills@googlegroups.com.
To unsubscribe from this group, send email to
legacy-ornamental-mills+unsubscr...@googlegroups.com.
For more options, visit this group at
http://groups.google.com/group/legacy-ornamental-mills?hl=en.
--
You received this message because you are subscribed to the Google Groups
"Legacy Ornamental Mills" group.
To post to this group, send email to legacy-ornamental-mills@googlegroups.com.
To unsubscribe from this group, send email to
legacy-ornamental-mills+unsubscr...@googlegroups.com.
For more options, visit this group at
http://groups.google.com/group/legacy-ornamental-mills?hl=en.
