If you need extra rail as you we were talking about you have plenty right on your mill replace all the bottom rails with some sort of available extrusion or even square tubing combined with that strong base you have made and you have plenty of spare rail. Thats what i did to get spare rail. You might even try to weld the 2 together without worry if it fails, because you still have the top ones and you could even cut the weld off if it didn't work for jigs and fixtures as you indicated before. Just a thought
Also another thought perhaps you might like to cut a middle piece out of the top of part your base some were if you need to do long vertical work on your mill Bill From: legacy-ornamental-mills@googlegroups.com [mailto:legacy-ornamental-mills@googlegroups.com] On Behalf Of finun...@aol.com Sent: Saturday, 31 August 2013 1:51 AM To: legacy-ornamental-mills@googlegroups.com Subject: joining two machines...progress report well, so far so good...the base is done, as you can see...dimensions are 182' long,19 1/2" deep and 17 1/4" high(no wheels...27" with wheels)...it is incredibly strong, in both the vertical and horizontal planes...probably could have used 1/2" ply instead of 3/4", and gotten sufficient results...because i used 3/4', each half, and the center joiner piece weighs quite a bit...i've roughly estimated it as 500 lbs....a bit of overkill to say the least, but it is very strong and stable...and the big bonus is that it breaks down into three pieces, none longer than 8ft., for ease of transport...still to come are four drawers to be bottom mounted...approx 36" wide by 18" deep by 8" high...two between the wheels and one on the outside of each wheel...these will also be designed to be completely removable to not increase the size of the "boxes", again for ease of transport...also not done yet are the steel rods that run the length of the base in the bottom corners...when these are in place and tightened, there will be no dip in the center at the bottom, between the two boxes...a bit difficult to photograph, it is longer than it appears in the photos -- You received this message because you are subscribed to the Google Groups "Legacy Ornamental Mills" group. To unsubscribe from this group and stop receiving emails from it, send an email to legacy-ornamental-mills+unsubscr...@googlegroups.com. To post to this group, send email to legacy-ornamental-mills@googlegroups.com. Visit this group at http://groups.google.com/group/legacy-ornamental-mills. For more options, visit https://groups.google.com/groups/opt_out. -- You received this message because you are subscribed to the Google Groups "Legacy Ornamental Mills" group. To unsubscribe from this group and stop receiving emails from it, send an email to legacy-ornamental-mills+unsubscr...@googlegroups.com. To post to this group, send email to legacy-ornamental-mills@googlegroups.com. Visit this group at http://groups.google.com/group/legacy-ornamental-mills. For more options, visit https://groups.google.com/groups/opt_out.