Yes I remember doing that a 2 inch corebox bit I think I used, a nice little spiral would look really good instead of the turned piece he has inside the ornament. I hope some has a try at one again unfortunately I am too busy house building at the moment
Bill From: [email protected] [mailto:[email protected]] On Behalf Of CURTIS GEORGE Sent: Friday, 12 December 2014 11:49 AM To: Legacy-Ornamental-Mills Subject: Inside-out turning video https://www.youtube.com/watch?v=adgB1z-hGVQ Inside out turning. Bill introduced us to inside-out turning a few years back.,In this video,The turning is done on the lathe. but I feel that the Legacy could do as well or better, in some cases. Dose anyone have any Christmas ideas or projects that could be done for a Holiday gift project? Come on people, Lets start talking. And and all ideas are welcome. C.A.G. No virus found in this message. Checked by AVG - www.avg.com Version: 2015.0.5577 / Virus Database: 4235/8718 - Release Date: 12/11/14 -- You received this message because you are subscribed to the Google Groups "Legacy Ornamental Mills" group. To unsubscribe from this group and stop receiving emails from it, send an email to [email protected]. To post to this group, send email to [email protected]. Visit this group at http://groups.google.com/group/legacy-ornamental-mills. For more options, visit https://groups.google.com/d/optout. -- You received this message because you are subscribed to the Google Groups "Legacy Ornamental Mills" group. To unsubscribe from this group and stop receiving emails from it, send an email to [email protected]. To post to this group, send email to [email protected]. Visit this group at http://groups.google.com/group/legacy-ornamental-mills. For more options, visit https://groups.google.com/d/optout.
