You must have a model 1000. Those where offset. -Tim
----- Original Message ----- From: Dexter Bland To: legacy-ornamental-mills@googlegroups.com Sent: Monday, February 09, 2015 12:00 PM Subject: Re: enlarging turning capacity of a legacy Joe, I have a question for you. Are you assuming that the spindle is centered in the machine or have you verified that with actually measuring? The reason I ask is that my machine is not exactly centered. The reason I know this is I turned my tail- stock over so I could get to the bolts from the top instead of normally from underneath. When I did that, my head and tail-stock were out of alignment. To fix this I also rolled the tail-stock and reinstalled the quick-release tail-stock components to face the proper direction. I'm not sure if this small difference will present any problem, but I thought I would bring it to your attention. For what it's worth, both you and Curt should be working in somebodies R&D section. You both ask the "what if" question all the time and usually come back with the answer of "why not". Amazing work. DB -- You received this message because you are subscribed to the Google Groups "Legacy Ornamental Mills" group. To unsubscribe from this group and stop receiving emails from it, send an email to legacy-ornamental-mills+unsubscr...@googlegroups.com. To post to this group, send email to legacy-ornamental-mills@googlegroups.com. Visit this group at http://groups.google.com/group/legacy-ornamental-mills. For more options, visit https://groups.google.com/d/optout. -- You received this message because you are subscribed to the Google Groups "Legacy Ornamental Mills" group. To unsubscribe from this group and stop receiving emails from it, send an email to legacy-ornamental-mills+unsubscr...@googlegroups.com. To post to this group, send email to legacy-ornamental-mills@googlegroups.com. Visit this group at http://groups.google.com/group/legacy-ornamental-mills. For more options, visit https://groups.google.com/d/optout.
