Thanks Tim. I like simple as well, but the purpose of this exercise is to push the envelope (so to speak) I've done simple and now I need to test my skills a little further , more complex turning seems the way to go... The neat thing here is this is only a three start rope, the plunging router bit is the only detail that make it look fancy, By the way guys, this plunging, is really just a modification of Mike Indexing method, I marked the drive gear (B on the standard gear set.) with a sharpy marker, and plunged down when my mark was in the up position. If I had let the router bit run as normal, I would have ended up with a three start rope. So in this case the buttons/plunging makes this look fancy, but the only thing different is the amount of time it takes to make. Advance, stop, plunge, repeat... until your done. YOU SEE Fancy,dose not always mean Hard, its just something different . ;-)
Have a good day. C.A.G. ----- Original Message ----- From: "Tim Krause" <artmarb...@comcast.net> To: legacy-ornamental-mills@googlegroups.com Sent: Monday, October 5, 2015 1:01:56 AM Subject: Re: rope and plung I'm liking the indexed plunge cuts. For my tastes, I'd go a little more simple with 1 or two starts. I know this was just a test. -Tim ----- Original Message ----- From: CURTIS GEORGE To: Legacy-Ornamental-Mills Sent: Sunday, October 04, 2015 12:13 PM Subject: rope and plung Here is a test cut, Please let me know what you think? Its a three start rope with a plunging index cut with the same router bit. C.A.G. -- -- You received this message because you are subscribed to the Google Groups "Legacy Ornamental Mills" group. To unsubscribe from this group and stop receiving emails from it, send an email to legacy-ornamental-mills+unsubscr...@googlegroups.com . To post to this group, send email to legacy-ornamental-mills@googlegroups.com . Visit this group at http://groups.google.com/group/legacy-ornamental-mills . For more options, visit https://groups.google.com/d/optout . -- You received this message because you are subscribed to the Google Groups "Legacy Ornamental Mills" group. To unsubscribe from this group and stop receiving emails from it, send an email to legacy-ornamental-mills+unsubscr...@googlegroups.com. To post to this group, send email to legacy-ornamental-mills@googlegroups.com. Visit this group at http://groups.google.com/group/legacy-ornamental-mills. For more options, visit https://groups.google.com/d/optout.
