As a spindle motor, I thought the consensus of the group was no higher than 300 rpm. I like the idea of making the pulley out of plywood. It's easier to find for some people.
-Tim ----- Original Message ----- From: Bill Bulkeley To: legacy-ornamental-mills@googlegroups.com Sent: Sunday, July 31, 2016 7:44 AM Subject: RE: Pulley for the Woodchuck Sounds good 300rpm is faster than i would use but if i remember Tim suggested it would work ok. 200 is as fast as I would go But your saying you have been using 300 ok, great with a slow saddle feed you must be getting a nice smooth finish Are you using a surface planning bit or perhaps a corbox bit? Bill -- You received this message because you are subscribed to the Google Groups "Legacy Ornamental Mills" group. To unsubscribe from this group and stop receiving emails from it, send an email to legacy-ornamental-mills+unsubscr...@googlegroups.com. To post to this group, send email to legacy-ornamental-mills@googlegroups.com. Visit this group at https://groups.google.com/group/legacy-ornamental-mills. For more options, visit https://groups.google.com/d/optout.
