The ruler is 14" long. 7" both side. It's designed for the y axis. The big difference between my ruler and others is mine is 1/16th" increments. It was designed with the Incra racks in mind so you could get a repeatable location everytime. It was a simple bolt on accessory.
On Jan 30, 2020, 2:13 PM, at 2:13 PM, MWF <mwfos...@earthlink.net> wrote: >Tim, > > >Sorry - I was not being negative about the length of your tape. > > >It looked to be about 16(?)" on either side of the Zero - less than 3' >total. (I figured that was as large as you made it for your project and >that was all the length that Curtis needed. Or, it was longer - but >since Curtis needed less, he cut it down.) > > >I went back and re-read the post (couldn't find the photo Curtis >posted) and then realized he needed it for the Y-Axis. In my mind I >was thinking he wanted it for the X-Axis. > >How long are yours? (The amount either side of zero if a "Centering >tape" or length if you make them in either L to R and R to L layout?) > >I'm asking in case you still have/make them and maybe some Group >Members may be looking for one/some. > >Have a Terrific Thursday! > >Mac >_____________________________________________ >_____________________________________________ > >-----Original Message----- >From: artmarb...@comcast.net >Sent: Jan 30, 2020 4:26 PM >To: legacy-ornamental-mills@googlegroups.com >Subject: RE: Measuring Tapes - L to R and R to L reading > >My custom rule is not too short. It’s the amount of a stock mill. > > > >From: legacy-ornamental-mills@googlegroups.com ><legacy-ornamental-mills@googlegroups.com> On Behalf Of MWF >Sent: Thursday, January 30, 2020 11:51 AM >To: Legacy Goog Group <legacy-ornamental-mills@googlegroups.com> >Subject: Measuring Tapes - L to R and R to L reading > > > >Curtis, A week or so ago you asked about measuring tapes - and Tim was >kind enough to gift you one (You deserved it.) > > > >I just came across these - they are in an email I received from >Woodcraft. > >Check them out. (The one from Tim is somewhat short. Perhaps that's >all you needed.) > >Not sure how long you needed - but these are in the 12" to 16' range. > >If you don't need them, I am sure other Group members will. > > > >Measuring Tapes: L to R and R to L > > > >Enjoy. > >Mac > >-- >You received this message because you are subscribed to the Google >Groups "Legacy Ornamental Mills" group. >To unsubscribe from this group and stop receiving emails from it, send >an email to legacy-ornamental-mills+unsubscr...@googlegroups.com. >To view this discussion on the web visit >https://groups.google.com/d/msgid/legacy-ornamental-mills/927769362.6316.1580422385081%40wamui-abby.atl.sa.earthlink.net. -- You received this message because you are subscribed to the Google Groups "Legacy Ornamental Mills" group. To unsubscribe from this group and stop receiving emails from it, send an email to legacy-ornamental-mills+unsubscr...@googlegroups.com. To view this discussion on the web visit https://groups.google.com/d/msgid/legacy-ornamental-mills/195b7439-6194-4117-84af-2429026eab67%40comcast.net.
