Ok mac yes your right it is not a 900 at all it was made from all the spare parts I had around the shop. And yes my trusty triton all my legacys and my router table and anything else I use a router has the key hole holes in it to move routers about from machine to mill to table
Now the slab was 2ft 3 inches average wide and 11 ft 3 long the cutter is 2 inches wide the overlap was 1/32 to 1/16 depending how close we got it and the cut was 1/8 thick most of the time 3 cuts on average to clean it up each side 2 rougher and 1 finish cut. And I used my auto quick travers to run the router back to the start after each cut along the slab “son push it back that’s it stop there” “now move it over”, “ok turn it on” my quick travers is voice activated. 😊 the feed is me sitting in a arm chair pulling a rope. So I think going along the slab is easier than across were I would do it all just saying Bill From: legacy-ornamental-mills@googlegroups.com <legacy-ornamental-mills@googlegroups.com> On Behalf Of MWF Sent: Sunday, 5 April 2020 1:05 PM To: legacy-ornamental-mills@googlegroups.com Subject: Re: slabing on the 900 mill Curt / Bill, That rig does not look like a LOM 900 to me. Appears it may have some parts & pieces from a LOM 900 as part of its construct. Bill, Tell us what you have here, please. Looks more like a LOM version of Johnny Cash's "One Piece at a Time" Cadillac. I also notice you are using your trusty Triton router on the sled. Still have/using the same one? Thanks inn advance for your replies to the above. Cheers! Mac _____ _____ -----Original Message----- From: 'Curt George' via Legacy Ornamental Mills Sent: Apr 4, 2020 1:38 PM To: legacy-ornamental-mills@googlegroups.com <mailto:legacy-ornamental-mills@googlegroups.com> Subject: slabing on the 900 mill Hello Everyone. this is 3yrs old now. But I like the idea, here is Bill using the 900. Way to think out side the box Bill. ;-) C.A.G. https://www.youtube.com/watch?v=km6XSLQVo3Y -- You received this message because you are subscribed to the Google Groups "Legacy Ornamental Mills" group. To unsubscribe from this group and stop receiving emails from it, send an email to legacy-ornamental-mills+unsubscr...@googlegroups.com <mailto:legacy-ornamental-mills+unsubscr...@googlegroups.com> . To view this discussion on the web visit https://groups.google.com/d/msgid/legacy-ornamental-mills/1085101067.9065.1586055884357%40wamui-abby.atl.sa.earthlink.net <https://groups.google.com/d/msgid/legacy-ornamental-mills/1085101067.9065.1586055884357%40wamui-abby.atl.sa.earthlink.net?utm_medium=email&utm_source=footer> . -- This email has been checked for viruses by Avast antivirus software. https://www.avast.com/antivirus -- You received this message because you are subscribed to the Google Groups "Legacy Ornamental Mills" group. To unsubscribe from this group and stop receiving emails from it, send an email to legacy-ornamental-mills+unsubscr...@googlegroups.com. To view this discussion on the web visit https://groups.google.com/d/msgid/legacy-ornamental-mills/000201d60afe%246b1f9090%24415eb1b0%24%40mmnet.com.au.
