Glad they all offered some good help. It's endless what some of the long timers know.
Kind Regards, Timothy J. Ziegler Ziegler WoodWork & Specialty 14171 160th Ave. Foreston MN 56330 320-294-5798 shop 320-630-2243 cell On Sun, Oct 31, 2021 at 6:33 PM B G <barrysgro...@gmail.com> wrote: > Thanks for the help guys. This was a loose drive gear. I 3D printed a > wider spacer to take out the wobble. > Much appreciated. > -Barry > > On Saturday, October 23, 2021 at 6:43:49 AM UTC-4 timjz...@gmail.com > wrote: > >> Welcome Barry, >> >> You certainly came to the right place for advice. >> I would advise doing Like Curt suggested and watch >> when you begin turning your crank or drive motor. Pay attention >> to what Tim Krause suggested about the drive gear shaft to see if >> something is bent. >> Lets figure this out and see what you can make. >> Kind Regards, >> >> Timothy J. Ziegler >> Ziegler WoodWork & Specialty >> 14171 160th Ave. >> Foreston MN 56330 >> >> 320-294-5798 <(320)%20294-5798> shop >> 320-630-2243 <(320)%20630-2243> cell >> >> >> On Fri, Oct 22, 2021 at 10:54 PM B G <barrys...@gmail.com> wrote: >> >>> Hi all, >>> First post here and trying to get some help on my Legacy gear >>> alignment. New machine to me and I see wear indicating alignment issues. >>> I'm wondering if I can get some pointers and/or pictures on what the gear >>> and spacer stack should include to address? >>> >>> Thanks in advance! >>> [image: 20210501_160323.jpg] >>> >>> -- >>> You received this message because you are subscribed to the Google >>> Groups "Legacy Ornamental Mills" group. >>> To unsubscribe from this group and stop receiving emails from it, send >>> an email to legacy-ornamental...@googlegroups.com. >>> To view this discussion on the web visit >>> https://groups.google.com/d/msgid/legacy-ornamental-mills/2af608ad-9593-4586-8d02-a00d9984f81fn%40googlegroups.com >>> <https://groups.google.com/d/msgid/legacy-ornamental-mills/2af608ad-9593-4586-8d02-a00d9984f81fn%40googlegroups.com?utm_medium=email&utm_source=footer> >>> . >>> >> -- > You received this message because you are subscribed to the Google Groups > "Legacy Ornamental Mills" group. > To unsubscribe from this group and stop receiving emails from it, send an > email to legacy-ornamental-mills+unsubscr...@googlegroups.com. > To view this discussion on the web visit > https://groups.google.com/d/msgid/legacy-ornamental-mills/9c86d7ae-1624-49af-96f9-eb2eb11ba868n%40googlegroups.com > <https://groups.google.com/d/msgid/legacy-ornamental-mills/9c86d7ae-1624-49af-96f9-eb2eb11ba868n%40googlegroups.com?utm_medium=email&utm_source=footer> > . > -- You received this message because you are subscribed to the Google Groups "Legacy Ornamental Mills" group. To unsubscribe from this group and stop receiving emails from it, send an email to legacy-ornamental-mills+unsubscr...@googlegroups.com. To view this discussion on the web visit https://groups.google.com/d/msgid/legacy-ornamental-mills/CAMBiJLG%3D3j%3D0ggWdygH9f38A1fjf6x95t0V07wUNstfvP-MOOg%40mail.gmail.com.