Hi Elber, you need to activate the "3-phase mode" which is descibed for I2C or something, but works for SPI as well.
Then you can read/write at the other clock edge. Best Stefan ----- Ursprüngliche Mail ---- Von: Elberlee <[email protected]> An: [email protected] Gesendet: Donnerstag, den 5. Mai 2011, 7:36:50 Uhr Betreff: Re: only two of four SPI modes supported by FT4232H?? Hello, Stefan, I also met the problem of the mode limitation in d2xx programming, the device I use is FT2232, and I need the SPI could be run under the mode of CPOL = 0 and CPHA =1, until now I still did not find a way to figure it out. Have you found some solution for the problem? Thank you so much for your consideration. Best Regards, Elber -- View this message in context: http://libftdi.141977.n3.nabble.com/only-two-of-four-SPI-modes-supported-by-FT4232H-tp2527060p2903210.html Sent from the libFTDI mailing list archive at Nabble.com. -- libftdi - see http://www.intra2net.com/en/developer/libftdi for details. To unsubscribe send a mail to [email protected] -- libftdi - see http://www.intra2net.com/en/developer/libftdi for details. To unsubscribe send a mail to [email protected]
