Hi,
I'm using libftdi indirectly indirectly through pylibftdi, and have
encountered a problem that seems to be in libftdi. I think pylibftdi isn't
causing the problem, though it's possible that my analysis is wrong.
I'm using a C232HM-DDHSL-0 cable, base don the FT232H chip, in bit-bang
mode. That's working fine in a simple test program. When I try to integrate
it in a larger system, and attempt to open it, I get the error:
File "/usr/lib/python3.7/site-packages/pylibftdi/device.py", line 173, in
open
raise FtdiError(msg)
pylibftdi._base.FtdiError: b'usb_open() failed' (-4)
The larger system has a second FTDI device, a US232R cable using an FT232RQ
chip. However, I am specifically requesting an open of the cable I want by
serial number. That works fine as long as only the cable I want is plugged
in, but fails if the second cable is also plugged in.
It appears that the reason for this is that the permissions on the second
cable are not set for world access. The libftdi code appears to error out
as soon as it encounters an FTDI device it can't open, and does not proceed
to try opening other devices.
If I set the permissions on the device I _don't_ want to use to 666 (world
read/write), then I can open the device I _do_ want without any problem.
In my opinion, the code should not return the "usb_open() failed" error
until it has tried all of the possible devices and not found a suitable
match for the serial number I've requested, even if some other device can't
be opened.
Best regards,
Eric Smith
--
************************
*This message may contain privileged
or confidential information for the sole use of the intended recipient.
Any review or distribution by others is strictly prohibited. If you are
not the intended recipient of this message, you may not make use of, or
rely in any way on this information. You should immediately notify the
sender by reply email and destroy this message. Please advise us
immediately if you or your employer do not consent to Internet email for
messages of this kind.*
************************
--
libftdi - see http://www.intra2net.com/en/developer/libftdi for details.
To unsubscribe send a mail to [email protected]
