On Mon, Sep 19, 2022 at 03:35:10PM +0200, Laszlo Ersek wrote:
> +At the bottom of the dialog, the C<Refresh disks> button instructs
> +virt-p2v to re-enumerate the fixed hard disks and the removable media
> +drives. (Note that the button will also reset the currently active
> +selections in both of those panels.) This button is useful in
> +combination with the C<XTerm> button on the L</SSH CONFIGURATION
> +DIALOG>: in the XTerm window, you can expose further block devices to
> +the kernel (such as LUNs from iSCSI targets), and the C<Refresh disks>
> +button allows virt-p2v to learn about all the block devices again.
> +
> │
> Network interfaces │
> │
^
Here (and earlier) in the same file ...
> @@ -239,10 +248,10 @@ the interface to be identified by the operator.
> When you are ready to begin the conversion, press the
> C<Start conversion> button:
>
> - │
> - [ Back ] [ Start conversion ] │
> - │
> - ─ ─ ───────────────────────────────────────┘
> + │
> + [ Back ] [ Refresh disks ] [ Start conversion ] │
> + │
> + ─ ─ ──────────────────────────────────────────────────────────┘
... I think you need to move the │ (vertical line) in the earlier
sections over to the right to line up.
Rich.
--
Richard Jones, Virtualization Group, Red Hat http://people.redhat.com/~rjones
Read my programming and virtualization blog: http://rwmj.wordpress.com
virt-builder quickly builds VMs from scratch
http://libguestfs.org/virt-builder.1.html
_______________________________________________
Libguestfs mailing list
[email protected]
https://listman.redhat.com/mailman/listinfo/libguestfs
