Date: Tue, 01 Jun 2004 07:29:23 +0000 From: "Matt Hanson" <[EMAIL PROTECTED]> Subject: RE: [LIB] Re: EZ-Drive installer - WORKED!
Okay Mark... great! One more case study for the argument for installing drive overlay even though the Windows OSs don't always need it. This confirms again that if you're going to do imaging or partitioning within a Windows OS on a >8GB HDD, drive overlay is going to be needed.
Now make sure you set aside 32MB+ for the 50/70 or 62MB+ partition space for the 100/110 around the 8GB boundry so your Lib doesn't write over data there if it's ever forced into hibernation. Lots of recent posts on that procedure in the archives.
Matt
From: Mark Srebnik <[EMAIL PROTECTED]>
That did it Matt!
PartitionMagic reports partitions are fine now and DriveImage worked great!
Thanks!!!
Mark
on 5/31/04 1:23 AM, Matt Hanson at [EMAIL PROTECTED] wrote:
>> From: Mark Srebnik <[EMAIL PROTECTED]>
>>
>> Could you please send it??
>
> Here you go Mark. Unzip and run the .eze and run it to create a boot floppy
> that will install EZ-Drive. You can follow my instructions from my last
> post... but here's a bit more about some menus I wasn't clear on:
>
> EZ-BIOS Setup:
> ---------------------------------
>
> * Select 2nd menu option > 'Advanced Options' (1st is 'Fully Automatic
> Install)
> * From the 'Advanced Options' select "EZ-Bios Setup"
> * At message: 'EZ-BIOS is not installed. Install now?', choose 'Yes' and
> exit all screens to reboot.
>
> From then on, you must hit 'CTRL' when prompted by EZ-Drive at boot in order
> to boot from a floppy. Leave the FD out of drive, hit CTRL, insert FD, hit
> an y key.
>
> From what you've written, my bet is that your problems with PM8 and
> DriveImage will probably disappear. If for some reason it's a no-go... try
> Symantec support via email (very slow and frustrating), or try the
> Compuserve Windows and/or PC Hardware forums
>
> For EZ-BIOS Uninstall:
> ---------------------------------
>
> * 2nd menu option > 'Advanced Options' (1st is 'Fully Automatic Install)
> * 'Advanced Options' select "EZ-Bios Setup"
> * Select "Controlled by EZ-BIOS" and hit ENTER
> * Select 'Exit and save changes' and it ENTER
> . Will exit to "EZ-Bios Setup"
> * Re-enter "EZ-Bios Setup" menu.
> * Select "Uninstall EZ-BIOS
> * Exit program
>
> Get back to me with a post to the list, this going right to you.
>
> Good luck.
>
> Matt
_________________________________________________________________
Stop worrying about overloading your inbox - get MSN Hotmail Extra Storage! http://join.msn.click-url.com/go/onm00200362ave/direct/01/
************************************************************** http://libretto.basiclink.com - Libretto mailing list http://www.silverace.com/libretto/ - Archives
-------TO UNSUBSCRIBE-------
Reply to any of the list messages. The reply mail should be
addressed to: [EMAIL PROTECTED] - Then replace any text
on the message's subject line: cmd:unsubscribe
--------TO UNSUBSCRIBE DIGEST------
Do above but with this on subject line: cmd:unsubscribe digest
**************************************************************