Thanks Mats, I just did as you indicated and it works. Thanks really. I am a bit surprise. The only doubt is that when opening GSview it says that you need to register for Ghostview. Does it means that one have to buy that piece of sotware?
Thanks carlos ----- Original Message ----- From: "Mats Bengtsson" <[EMAIL PROTECTED]> To: "Carlos Garcia Suarez" <[EMAIL PROTECTED]> Cc: <[EMAIL PROTECTED]> Sent: Saturday, April 20, 2002 2:41 PM Subject: Re: GSview problem > Dear support, > > I have followed all instructions and installed from hard disk the whole lilypond package. Everything looked fine until I tried to run gsview32 it can not find the program. > > I am running unders Windows2000. > > What can I do? For some silly reason, the Postscript viewing program isn't installed by default. Just rerun the setup.exe program (don't worry, it will not try to reinstall the things you already have installed). When you come to the setup page entitled "Select packages to install", click on the "View" button at the top right corner and then click on the arrows for the line with gsview, this will select both gs and gsview, then click on Next to finish the installation. On my machine, GSview did not find the correct path to the ghostscript program, even though we have recently tried to fix this problems. The solution in my case was to click on Options->Advanced configure, then on "Defaults" and "Ok". However, I already have another copy of GSview installed on the machine as a Windows application. Also, I installed as an ordinary user on a Windows 2000 machine so there might be some problems with access rights. Hopefully it will work on your machine without these extra steps. Regards /Mats _______________________________________________ Lilypond-user mailing list [EMAIL PROTECTED] http://mail.gnu.org/mailman/listinfo/lilypond-user