You can't have searched very thoroughly, this topic has
been discussed several times on the mailing lists.
There are two main solutions for you:
- Update to version 2.11.x where the voltas appear
above the chord names by default. Although 2.11 is an
"unstable development" version, I would still classify it
as at least as good as 2.10 if you want to do serious
typesetting.
- Take a look at the "volta-chord-names.ly" example
in the Tips and Tricks document in the documentation
for version 2.10.
/Mats
eric raeburn wrote:
There was a short thread on this topic in Feb-March 2003 ("Chords
under voltas?"), apparently unresolved, and I could find no more
recent discussion of this topic.
I am using Lilypond to produce jazz leadsheets. Lilypond prints chord
symbols above volta lines. This is most unorthodox and
disconcerting--the symbols should be above the staff but below the
volta. I am using 2.10.29.
Is there a workaround, or should this be reported as a bug?
Thanks,
-Eric
_______________________________________________
lilypond-user mailing list
lilypond-user@gnu.org
http://lists.gnu.org/mailman/listinfo/lilypond-user
--
=============================================
Mats Bengtsson
Signal Processing
Signals, Sensors and Systems
Royal Institute of Technology
SE-100 44 STOCKHOLM
Sweden
Phone: (+46) 8 790 8463
Fax: (+46) 8 790 7260
Email: [EMAIL PROTECTED]
WWW: http://www.s3.kth.se/~mabe
=============================================
_______________________________________________
lilypond-user mailing list
lilypond-user@gnu.org
http://lists.gnu.org/mailman/listinfo/lilypond-user