Hello,
I changed the WRL2-25 output to another soundcard, other than the delta 44
and WLR2-25 now starts up and runs OK.
Watzo1-01 has a peculiarity.
When I start from a fresh down load without a par_ui setup file:
I enter a S for setup,
font scale (1 to 5): I select 3 as I had with WLR2-25
percentage of screen width (33 to 98): I chose 95
network base port (50000 to 65000): I chose 50005
[239.255.0.00] new last byte (0 to 15): I chose 0 (and got 239.255.0.0)
What should be the criteria to select ?
I guess that it must exactly match the WLR2-25 program in use.
percentage screen height to use (25 to 92): I chose 92
max scratch file in power of two (26 to 36): I chose 36
What should be the criteria to select a number, memory size ?
waterfall lines limitation (50 and above): I chose 50
I save this data and a par_ui setup file is created.
If I want to go back and change this setup file because I am now using a
different
address like 235.255.0.0 vs. what I set up in WLR2-25 as 235.255.0.10
There is no opportunity to change unless I get out of watzo and delete
the par_ui set up file.
and create a new par_ui file with a new setup.
Possibly a function key to enable a new set up is needed.
If I goofed up and set up the network base port (50000 thru 65000) with
the wrong number,
I can never change it, even with a new par_ui setup file. It seems to
be set for life.......
I am using a simple network with a DSL modem, to a 4 port router,
to 2 computers, and a network printer. Computers are win XP on a 100
base wired network.
Must WLR2-25 be started on the "front end" (master) computer, enable
network RX,
then startup watzo1-01 on the second computer to receive the data ?
Do I also need to start up WLR2-25 on the second (slave) computer ?
Is watzo simply the comms link between 2 each WLR2-25 applications ?
Longer term objective is to extend the network on ethernet fiber optic
transceivers and remotely locate the RX system outside near the planned
antennas.
Stan, W1LE
#############################################################
This message is sent to you because you are subscribed to
the mailing list <linrad@antennspecialisten.se>.
To unsubscribe, E-mail to: <[EMAIL PROTECTED]>
To switch to the DIGEST mode, E-mail to <[EMAIL PROTECTED]>
To switch to the INDEX mode, E-mail to <[EMAIL PROTECTED]>
Send administrative queries to <[EMAIL PROTECTED]>