Hello Stan,
> Master computer is at the receiver in the shack, Win XP sp2 > HP Pavilion, 100 base network activated, 2 GHz Celeron, 256MB RAM > > Start WLR2-25 and set N, network parameters to: > 1, base port = 50050 > 2, send address = 239.255.0.0 > 3. receive address = 239.255.0.0 > 4. send raw data in 16 bit format ON (port 50050) > (changes color to yellow ! ) > 5 thru 10 OFF > > exit network setup and save with a W OK. > toggle R for network input > (does this enable RAW16 data input into the network ?? ) No. R means receive from the network. When you press R you get to the network setup screen, you are supposed to tell linrad what kind of input you want to receive. A master has to be put in transmit mode. Press T and note that "NETSEND" comes up in red. You may press W here to have the network active in tx mode next time Linrad is started. > go to mode A for weak signals and verify it is working with a test tone. > All OK, but I see NO network activity, > I would expect to see streaming data in one direction, at least. No. You are not in any net mode. > Slave computer in the auxiliary shack, Win XP sp2 > ASUS 2.4 Ghz Pent4, 1 GB RAM, 100 base network activated > > start WLR2-25 and set N parameters to: > 1. base port = 50050 > 2. send address = 239.255.0.0 > 3. receive address = 239.255.0.0 > 4 thru 9 all set to OFF > 10, RX input from network ON raw data 16 bit > > exit network setup save N setup with a W > > At the WLR2-25 startup page, toggle T for NETSEND > (as indicated in the upper left in red.) ?????????????? This can not be the whole story. You can only have NETSEND in red if your network setup has enabled something (4 through 9) When NETSEND is present in red, Linrad will start acting as a master as soon as you enter a processing mode. > Mode A for weak signals, > > I get displayed: > listening to network for RAW16 RX input > Group 239.255.0.0, port 50050 Here you have had "NETWORK RX INPUT xxxx" in red on the top line. It is now a slave. When you enter a processing mode Linrad will wait for the network data from a master. > When I try to X for exit, I get > > internal error 1269 > [1269] waiting for master was interrupted from keyboard > press any key > > pressing any key dumps me out of Linrad Yes. You are supposed to start a master on the network now:-) This computer is sucessfully set up as a slave. --------------------------------------------------------- Setup for a master: 1) Press N to select data format (e.g. RAW16). 2) Press T to tell Linrad to make net transmit active. 3) Press W to remember this computer is the master. 4) Press e.g. A to start operation. The system monitor will show network activity. Setup for a slave: 1) Press N to select data format (e.g. RAW16). 2) Press R to tell Linrad to use the net for input. 3) Press W to remember this computer is a slave. 4) Press e.g. A to start operation. Good luck! 73 Leif / SM5BSZ ############################################################# This message is sent to you because you are subscribed to the mailing list <linrad@antennspecialisten.se>. To unsubscribe, E-mail to: <[EMAIL PROTECTED]> To switch to the DIGEST mode, E-mail to <[EMAIL PROTECTED]> To switch to the INDEX mode, E-mail to <[EMAIL PROTECTED]> Send administrative queries to <[EMAIL PROTECTED]>