Hi, Dan,
I have a couple of more questions the answers to which might help to
figure things out if you are still having problems with segmentation
faults. As Leif noted, you should not worry about doing the hardware
test. Go right to "U" to set up soundcards, then to "D" SSB OR "A"
Weak Signal CW.
1. Were you using OSS from the first, before you started with Linrad?
2. If so, did FC6 come with it installed or did you add it?
3. Is the audio now working in Linrad when you go into "D" or "A" for
example from the main screen?
4. If not, what exactly happens when you to to "U" from the main screen?
5. What version of nasm are you using?
6. What kernel version are you using?
7. Is your machine 64 bit or 32 bit and if 64 bit are you running 64
bit version of FC6?
If things are working you can ignore all of these questions ;)
73,
W3SZ
Roger Rehr
http://www.nitehawk.com/w3sz
Quoting Dan Sawyer <[EMAIL PROTECTED]>:
All,
xlinrad is now building and running. However attempts to perform the z
command, hardware interface test, produces a segmentation fault.
Other sound apps, mplayer, etc run fine. The system is using OSS.
Thanks - Dan
#############################################################
This message is sent to you because you are subscribed to
the mailing list <linrad@antennspecialisten.se>.
To unsubscribe, E-mail to: <[EMAIL PROTECTED]>
To switch to the DIGEST mode, E-mail to <[EMAIL PROTECTED]>
To switch to the INDEX mode, E-mail to <[EMAIL PROTECTED]>
Send administrative queries to <[EMAIL PROTECTED]>
Roger Rehr
W3SZ
http://www.nitehawk.com/w3sz
#############################################################
This message is sent to you because you are subscribed to
the mailing list <linrad@antennspecialisten.se>.
To unsubscribe, E-mail to: <[EMAIL PROTECTED]>
To switch to the DIGEST mode, E-mail to <[EMAIL PROTECTED]>
To switch to the INDEX mode, E-mail to <[EMAIL PROTECTED]>
Send administrative queries to <[EMAIL PROTECTED]>
