We did a "minimum install" without KDE for SLES9 on a z890. Then, we activated "remote administration under yast" and some X rpm's were installed. When we ssh and start vncserver and run yast2 from a vnc client under windows (the same when using the IE browser) we run into a situation. The last few rows of pixels on the yast2 screen are missing. It is not a problem in most screens where there is a lot of room, but in "software->install/remove programs", the "IGNORE" and "INSTALL" buttons are missing. I figured out what the buttoms were by using yast. I suspect the problem is with framebuffer. If it was X, i would think it is one of the "mode" parameters but I can't find XF86Config anywhere. if anybody know a way around this, it will be appreciated. Regards, [EMAIL PROTECTED] NCCI Boca Raton, Florida 561.893.2415 greetings / avec mes meilleures salutations / Cordialmente mit freundlichen Gr��en / Med v�nlig h�lsning The information contained in this e-mail message is intended only for the personal and confidential use of the recipient(s) named above. This message may be an attorney-client communication and/or work product and as such is privileged and confidential. If the reader of this message is not the intended recipient or an agent responsible for delivering it to the intended recipient, you are hereby notified that you have received this document in error and that any review, dissemination, distribution, or copying of this message is strictly prohibited. If you have received this communication in error, please notify us immediately by e-mail, and delete the original message. ---------------------------------------------------------------------- For LINUX-390 subscribe / signoff / archive access instructions, send email to [EMAIL PROTECTED] with the message: INFO LINUX-390 or visit http://www.marist.edu/htbin/wlvindex?LINUX-390
