I formatted these using YAST, I believe. Is there an option I should have looked for? This is an LPAR install, not VM so if there are VM commands involved I'm unable to perform those.
Tim Hare Senior Systems Programmer Florida Department of Transportation (850) 414-4209 Linux on 390 Port <LINUX-390@VM.MARIST.EDU> wrote on 12/13/2006 10:35:35 AM: > > :Warning ON > > VM Newbie Answering a question > > Welcome to the party...8-) > > > We do a dasdfmt command with the -l option to add a volume name. > Example: > > > > dasdfmt -b 4096 -y -f /dev/dasdb -l vol001 & > > > > Now when you view it from MVS it shows as vol001 > > A much better approach than letting it default, esp since the addresses > will change when he does the copy. > > ---------------------------------------------------------------------- > For LINUX-390 subscribe / signoff / archive access instructions, > send email to [EMAIL PROTECTED] with the message: INFO LINUX-390 or visit > http://www.marist.edu/htbin/wlvindex?LINUX-390 ---------------------------------------------------------------------- For LINUX-390 subscribe / signoff / archive access instructions, send email to [EMAIL PROTECTED] with the message: INFO LINUX-390 or visit http://www.marist.edu/htbin/wlvindex?LINUX-390