Whatever the partition number on the source volume, will be the partition number on the target volume. So, if your root partition is /dev/dasda2 on the source, then in your case the root partition will be /dev/dasdb2 on the system where you are modifying it. If it was /dev/dasda3, then use /dev/dasdb3.
Mark Post -----Original Message----- From: Linux on 390 Port [mailto:[EMAIL PROTECTED] On Behalf Of Jones, Russell Sent: Tuesday, January 16, 2007 5:01 PM To: LINUX-390@VM.MARIST.EDU Subject: Re: New HOWTO: Cloning Red Hat Linux Running in an LPAR I have been working through the HowTo on Cloning Red Hat Linux. I copied my Linux dasd volume using MVS. I brought the new volume online, and it showed up as dasdb. When I mount /dev/dasdb1, I seems to be mounting the boot partition and not the root file system. Any suggestions would be appreciated. Thanks, Russ Jones ---------------------------------------------------------------------- For LINUX-390 subscribe / signoff / archive access instructions, send email to [EMAIL PROTECTED] with the message: INFO LINUX-390 or visit http://www.marist.edu/htbin/wlvindex?LINUX-390
