With z10's new 2 ports per chpid, perhaps you have to manually set
/sys/bus/ccwgroup/drivers/qeth/.../portno (?)
Marcy Cortes wrote:
-OK,
I went and tried it with the sles10 sp2 rescue system image from the DVD to
make sure it wasn't my guest.
Same problem.
I then went and tried the sles10 SP2 rescue system image from a z9 with z/VM
5.3 That worked.
So, I'm sure the HW is fine (it runs the vswitch - why couldn't it run it
dedicated, right?)
So, it's likely z/VM 5.4, or perhaps the z10 - but I find that hard to
believe since the OSA does function on vswitch.
I guess I'll open a PMR.
Marcy
Yep, same chpid.
This is on a z10, z/VM 5.4, sles 10 sp2.
Maybe I should go try in on a z9, z/VM 5.3 and sles9 sp4 just for grins
since it sounds like it ought to work!
Marcy
"This message may contain confidential and/or privileged information. If you
are not the addressee or authorized to receive this for the addressee, you
must not use, copy, disclose, or take any action based on this message or
any information herein. If you have received this message in error, please
advise the sender immediately by reply e-mail and delete this message. Thank
you for your cooperation."
-----Original Message-----
From: Linux on 390 Port [EMAIL PROTECTED] On Behalf Of Mark Post
Sent: Tuesday, October 07, 2008 3:56 PM
To: LINUX-390@VM.MARIST.EDU
Subject: Re: [LINUX-390] Change the Linux from VSWITCH to DEDICATEd OSA
addresses
On 10/7/2008 at 6:46 PM, in message
Marcy Cortes <[EMAIL PROTECTED]> wrote:
But that's got to be a big lie :) --- it is working if it is on a
vswitch. Just not with dedicates.
The cables are happy. The ports are happy. The physical switch is
happy.
Are you sure what is/was being used for the VSWITCH is on the same CHPID as
the new device you're trying to use? Each card has two possible cable
connections (4 with the new z10s).
Mark Post
----------------------------------------------------------------------
For LINUX-390 subscribe / signoff / archive access instructions, send email
to [EMAIL PROTECTED] with the message: INFO LINUX-390 or visit
http://www.marist.edu/htbin/wlvindex?LINUX-390
----------------------------------------------------------------------
For LINUX-390 subscribe / signoff / archive access instructions,
send email to [EMAIL PROTECTED] with the message: INFO LINUX-390 or visit
http://www.marist.edu/htbin/wlvindex?LINUX-390
--
Brad Hinson <[EMAIL PROTECTED]>
Sr. Support Engineer Lead, System z
Red Hat, Inc.
(919) 754-4198
www.redhat.com/z
----------------------------------------------------------------------
For LINUX-390 subscribe / signoff / archive access instructions,
send email to [EMAIL PROTECTED] with the message: INFO LINUX-390 or visit
http://www.marist.edu/htbin/wlvindex?LINUX-390
