SUSE or Red Hat? If SUSE, did you also enable boot.multipath? I usually use "insserv" instead of chkconfig on SUSE, so enter "insserv boot.multipath".
On Tue, Mar 27, 2012 at 3:04 PM, Michael MacIsaac <mike...@us.ibm.com> wrote: > So I did not use the FCP devices at install time. After install, I added > three LUNs, set up multipathing, set up an LVM and edited /etc/fstab so it > is mounted over /opt. > > I did a "chkconfig multipathd on" and rebooted. The LV did not mount. It > seems multipathd ran *after* /etc/fstab was read. After logging on, if I > then do a "mount /opt", it works fine > > Has anyone seen this? Does multipathd perhaps need some additional > "comments" in the insserv header so it starts earlier? > > Thanks. > > "Mike MacIsaac" <mike...@us.ibm.com> (845) 433-7061 > > ---------------------------------------------------------------------- > For LINUX-390 subscribe / signoff / archive access instructions, > send email to lists...@vm.marist.edu with the message: INFO LINUX-390 or visit > http://www.marist.edu/htbin/wlvindex?LINUX-390 > ---------------------------------------------------------------------- > For more information on Linux on System z, visit > http://wiki.linuxvm.org/ -- Bruce Hayden z/VM and Linux on System z ATS IBM, Endicott, NY ---------------------------------------------------------------------- For LINUX-390 subscribe / signoff / archive access instructions, send email to lists...@vm.marist.edu with the message: INFO LINUX-390 or visit http://www.marist.edu/htbin/wlvindex?LINUX-390 ---------------------------------------------------------------------- For more information on Linux on System z, visit http://wiki.linuxvm.org/
