Hello Scott and Mark... thanks for the reply. Tomorrow I'll have the Networking guy take a look at the actual switch ports, etc. and check some of his stuff.
Tom B. ----------------------------- This message (including any attachments) contains confidential information intended for a specific individual and purpose, and is protected by law. If you are not the intended recipient of this e-mail (even if the e-mail address above is yours), (i) you may not use, copy or retransmit it, (ii) please delete this message and (iii) please notify the sender immediately. Any disclosure, copying, or distribution of this message or the taking of any action based on it, is strictly prohibited. ----------------------------- -----Original Message----- From: Linux on 390 Port [mailto:LINUX-390@VM.MARIST.EDU] On Behalf Of Mark Post Sent: Tuesday, March 04, 2014 3:27 PM To: LINUX-390@VM.MARIST.EDU Subject: Re: DTCVSW2 BACKUP Not ready? >>> On 3/4/2014 at 03:16 PM, Tom Burkholder <tom.burkhol...@qvc.com> wrote: > I just noticed that my DTCVSW2 controller is showing Error: BACKUP Not > ready from the q vswitch command (probably not a good thing). Looks > like the paths are online. Does anybody know how to get the backup > controller DTCVSW2 back into a *ready* state (without taking an TCPIP > burp or outage)? This is a z/VM 6.2 single VM system. This question would likely get far more of a response on the IBMVM mailing list, but I'll give it a try. The problem isn't with DTCVSW2, just RDEV 160. You should probably check to make sure it's got a cable plugged in, that the physical switch sees it, etc. Perhaps look at the HMC to see if anything there shows problems with the card, etc. Mark Post ---------------------------------------------------------------------- For LINUX-390 subscribe / signoff / archive access instructions, send email to lists...@vm.marist.edu with the message: INFO LINUX-390 or visit http://www.marist.edu/htbin/wlvindex?LINUX-390 ---------------------------------------------------------------------- For more information on Linux on System z, visit http://wiki.linuxvm.org/ ---------------------------------------------------------------------- For LINUX-390 subscribe / signoff / archive access instructions, send email to lists...@vm.marist.edu with the message: INFO LINUX-390 or visit http://www.marist.edu/htbin/wlvindex?LINUX-390 ---------------------------------------------------------------------- For more information on Linux on System z, visit http://wiki.linuxvm.org/
