Hi,

I have an Assabet/Neponset phase 5 running the linux version 2.4.1-rmk1-np2.
I have a strange problem with the Ethernet PC Card on PCMCIA and with the
sound drivers  (UDA1341) on Neponset when I boot the kernel from the
bootldr.

When I boot my kernel with the bootldr (using a ext2 fs "ramdisk"), the
cardmgr is not able to recognize my Ethernet PC Card on PCMCIA (on
Neponset).  If the card is inserted before the cardmgr started, the system
will freeze.  If the card is inserted after the cardmgr is started the
system generates the following message: "cs: socket c1847000 timed out
during reset.  Try increasing setup delay". However, I am able to use the
Ethernet port on the Neponset card.  Also, if I am not able to use the sound
driver for codec 1341 (on Neponset) via the /dev/dsp or /dev/audio.  Each
time we tried to make access to the device the system freeze (no sound).

If I use the same kernel (except that the CONFIG_ANGELBOOT is set to Yes)
and the same ramdisk when I use the angelboot utility, I have no problem at
all.  I can use the sound driver UDA1341 on Neponset and the Ethernet PC
Card on PCMCIA with success.  I tried to figure out what is the difference
between the bootldr and the angelboot and I have no clue about the problem.


I used the version of the bootldr of November 26th,  2000.  I tried this
version with and without the bootldr-jd2.patch with the same results.

Can someone help me on this problem?  I am concerned especially for the
sound drivers since I can use the Ethernet port on Neponset.

Is there someone which have tried my configuration without problems
(specially using UDA1341 on Neponset using the bootldr not the angelboot)

P.S.  Also when I boot the kernel with angelboot,  each time it has an
activity on the Ethernet port on Neponset, my screen on Assabet blink.  It
seems that I have to replace a pull up resistor to eliminate this problem.
However, If I use the bootldr instead of angelboot, I do not have that
problem.

 
 <<...>> 
Sylvain Pérusse
Software Engineer

225 boul. Du Séminaire Sud              Email:   [EMAIL PROTECTED]
<mailto:[EMAIL PROTECTED]> 
Saint-Jean-sur-Richelieu                Phone: (450) 542-5798
Québec Canada J3B 8E9           Fax:     (450) 358-7704

_______________________________________________
http://lists.arm.linux.org.uk/mailman/listinfo/linux-arm
Please visit the above address for information on this list.

Reply via email to