I'm trying to get a Assabet board (phase 5) to run Linux; the board has 32 MB DRAM and I've removed the daughter board as I cannot get angelboot to download anything when it is attached. I'm using kernal 2.4.0-test2-1.2.3-2 from the hard hat linux people. Using angelboot (Ver 1.10) to download. I've tried the Brutus ramdisk.gz and the ramdisk_ks.gz from Wearablegroup.org people. But neither of them work for me. Initially I used the Brutus ramdisk getting the following output; Tux is on the screen of the Assabet and the cursor is blinking but minicom is locked up. ------ last section of the output -------- RAMDISK driver initialized: 16 RAM disks of 8192K size 1024 blocksize Uniform Multi-Platform E-IDE driver Revision: 6.31 ide: Assuming 50MHz system bus speed for PIO modes; override with idebus=xx RAMDISK: Compressed image found at block 0 SA1100 serial driver version 1.3 ttyS0 on SA1100 UART1 (irq 15) ttyS1 on SA1100 UART3 (irq 17) ttyS2 on SA1100 UART2 (irq 16), using IRDA UDA1341 audio driver initialized Linux PCMCIA Card Services 3.1.11 options: none NetWinder Floating Point Emulator V0.95 (c) 1998-1999 Rebel.com ds: no socket drivers loaded! VFS: Mounted root (ext2 filesystem). Freeing unused kernel memory: 64k init Kernel panic: No init found. Try passing init= option to kernel. ------------ end of output -------------- Now I tried copying the init command to a number of the alternate places that it can reside. Same results. Seems to be mounting the ramdisk but ..... So then I tried using the ramdisk_ks.gz, and realised this one is probably more useful to me but I'll be happy with either one going :-). But the output got a bit further, till it crashed ------ last section of the output -------- RAMDISK driver initialized: 16 RAM disks of 8192K size 1024 blocksize Uniform Multi-Platform E-IDE driver Revision: 6.31 ide: Assuming 50MHz system bus speed for PIO modes; override with idebus=xx RAMDISK: ext2 filesystem found at block 0 RAMDISK: Loading 8000 blocks [1 disk] into ram disk... - etc, etc - done. SA1100 serial driver version 1.3 ttyS0 on SA1100 UART1 (irq 15) ttyS1 on SA1100 UART3 (irq 17) ttyS2 on SA1100 UART2 (irq 16), using IRDA UDA1341 audio driver initialized Linux PCMCIA Card Services 3.1.11 options: none NetWinder Floating Point Emulator V0.95 (c) 1998-1999 Rebel.com ds: no socket drivers loaded! EXT2-fs warning: maximal mount count reached, running e2fsck is recommended VFS: Mounted root (ext2 filesystem). Freeing unused kernel memory: 64k init Internal error: branch through zero: 0 ------------ end of output ---------------------- I'm hoping that someone out there can tell me what it is that I'm doing wrong. I imagine it is staring me in the face but I cannot see it. I've been through the FAQ's on http://www.arm.linux.org.uk/, where it suggested I email this group so here I am. Thanks in advance. john _______________________________________________ http://lists.arm.linux.org.uk/mailman/listinfo/linux-arm Please visit the above address for information on this list.
