Hello,
I've been using gcc-2.95.2 + glibc-2.1.3 + binutils-2.10.1 combination
without any problem.
They were compiled cleanly.
ftp://ftp.gnu.org/gnu
----- Original Message -----
From: <[EMAIL PROTECTED]>
To: <[EMAIL PROTECTED]>
Sent: Thursday, April 12, 2001 7:28 PM
Subject: Binutils version ??
> I'm trying to build the toolchain and I downloaded binutils2.9.1 but when
I
> used it I got the following error while using trying to configure it:
>
> *** BFD does not support target arm-unknown-linux-gnu
>
> from bfd/config.bfd
>
> I invoked the configure utility using ./configure --target=arm-linux
> --prefix=/usr/arm242
>
> I'm trying to build it on a RedHat 6.2 system, if that has any bearing on
> the situation.
>
> I was working from the HowTo by Wookey etc. Now right at the end of the
> document it says I should be using version 2.9.5 as opposed to the web
page
> maintained by Phil Blundell that says 2.9.1.0.19a is the last one known to
> work on the arm. (The Howto says phils site has up to date info, so I'm
> confused.)
>
> If someone out there could provide a pointer to a site where I can
download
> a version of binutils that they have successfully compiled I would be most
> grateful. Or if there is something I'm obviously doing wrong and you can
> put me right I'd also be grateful.
>
> Thanks for your time.
>
> jon
>
> PS I did try to search the list archive held at
> http://www.geocrawler.com/lists/3/Linux/18/0/
> but it was down :-(
>
>
>
> _______________________________________________
> http://lists.arm.linux.org.uk/mailman/listinfo/linux-arm
> Please visit the above address for information on this list.
_______________________________________________
http://lists.arm.linux.org.uk/mailman/listinfo/linux-arm
Please visit the above address for information on this list.
