On Mon, Jun 11, 2001 at 05:36:10PM -0700, [EMAIL PROTECTED] wrote:
[followup set to linux-arm only; this is NOT a kernel related question,
so don't cross post between the lists]
> I am currently using the 'xscale-elf-gcc' compiler to build the kernel for
> IQ80310 board. I downloaded the latest one from
> ftp://xscale.mvista.com/pub/xscale/raven_for_xscale and installed
>
> It has some problem while building the zImage (init/main.c). In the end, it
> says "#error Sorry, your GCC is too old. It builds incorrect kernels."
>
> I am trying to cross compile from a pc. Is there some thing wrong. Can any
> one point me towards the correct direction.
Check out the archives for this list, there are many precompiled cross
compilers available that will do the trick.
Erik
--
J.A.K. (Erik) Mouw, Information and Communication Theory Group, Department
of Electrical Engineering, Faculty of Information Technology and Systems,
Delft University of Technology, PO BOX 5031, 2600 GA Delft, The Netherlands
Phone: +31-15-2783635 Fax: +31-15-2781843 Email: [EMAIL PROTECTED]
WWW: http://www-ict.its.tudelft.nl/~erik/
_______________________________________________
http://lists.arm.linux.org.uk/mailman/listinfo/linux-arm
Please visit the above address for information on this list.
