Hi,
If you really need 2 serial port, you can bring out the signals from the
header J3 pins (125,127) of the Assabet board for Serial port 3 and also
serial port1(131,133), some address and data lines for the CPLD glue logic
design and you should get moving on.
Hope this is the correct site to discuss this., else you know the site
manager will....
----- Original Message -----
From: "Supriyo Chatterjea" <[EMAIL PROTECTED]>
To: <[EMAIL PROTECTED]>
Sent: Monday, July 02, 2001 10:45 PM
Subject: Bluetooth on Assabet
> Hi,
>
> I'm trying to get an Assabet board running on the
> ARM Linux kernel to use the Ericsson Bluetooth module.
> I'm planning to use the Axis OpenBT stack.
>
> Now I need the serial port of the Assabet to connect
> to the PC so that I can send in the commands through
> Minicom.
>
> The problem is that the Ericsson BT module also uses
> the serial port for data transfer and the Assabet only
> has *one* serial port!
>
> I can't use the USB either since both the Assabet and
> the Ericsson have type "B" USB connectors. And I don't
> have a Neponset.
>
> Could someone please help shed some light on this
> problem?? Is there any simple solution?? :)
>
> Would appreciate any comments/remarks!
>
> Thanks,
> Supriyo
>
> __________________________________________________
> Do You Yahoo!?
> Yahoo! Greetings - Send dad a Father's Day Card!
> http://greetings.yahoo.com.sg/
>
> _______________________________________________
> http://lists.arm.linux.org.uk/mailman/listinfo/linux-arm
> Please visit the above address for information on this list.
_______________________________________________
http://lists.arm.linux.org.uk/mailman/listinfo/linux-arm
Please visit the above address for information on this list.
