Thilo,
> Which hardware (board/processor) are you working with?
i'm working the the elf board from inhand electronics, which is similiar in
design to the omnimeter, both of which have a sa-1100 processor
>
>
> - Did you configure a virtual terminal (CONFIG_VT)?
> - Did you configure a console on a virtual terminal (CONFIG_VT_CONSOLE)?
> - Did you configure the serial UART driver support for your hardware
> (e.g. for SA1100: CONFIG_SERIAL_SA1100)?
> - Did you configure console support for the serial UART driver
> (e.g. for SA1100: CONFIG_SERIAL_SA1100_CONSOLE)?
>
all of these items are configured in the kernel
>
> - Did you create the device files in the /dev directory
> (described e.g. for the SA1100 in Documentation/arm/SA1100/serial_UART)?
the devices have been created in the fs, however the kernel doesn't appear to
getting that far. i assume the system is kernel panicing, however due to the
fact that i can not see the console messages, i can't determine what the
problem is.
thanks
dave
_______________________________________________
http://lists.arm.linux.org.uk/mailman/listinfo/linux-arm
Please visit the above address for information on this list.
