On Mon, 2002-03-04 at 04:21, friend Hsu wrote: > Hi, how are you, > I want to use blob-2.0.5-pre2 for my assabet board. > After unpacking the "blob-2.0.5-pre2.gz", I > "configure" and "make" the source code directly. > Not any modification for the source code. > Then, there is a "blob" generated in src/blob > directory. > I downloaded the "blob" into my assabet by using > "jflash-linux", Re-power-up, and nothing appear on the > "minicom" of PC. > Could anybody tell me what happen? > Should I do any modification for the source code? > ".S" file or ".h" file? > I used the following command to configure it: > ./configure --with-linux-prefix=/TO/LINUX/KERNEL/PATH/ > --with-board=assabet --host=i386 > --enable-maintainer-mode --enable-blob-debug
did you setup your minicom setting? (correct baud, stop bits, etc, flow control off, correct serial port). Also, if the assabet has a diag led, you can verify that the blob is activating the LED) _______________________________________________ http://lists.arm.linux.org.uk/mailman/listinfo/linux-arm http://www.arm.linux.org.uk/armlinux/mailinglists.php Please visit the above addresses for information on this list.
