By the way, it crashes on this line
in the cs89x0_probe1 method in cs89x0.c
printk("PP_addr=0x%x\n", inw(ioaddr + ADD_PORT));
Ben Greear wrote:
> After following some good Advice from Bill about how to set up
> my .config, I was able to get the cube to boot 2.4.18-rmk4
>
> However, I did not have the ethernet driver in the build, so
> it was pretty useless....
>
>
> So, I enabled the cx89x0 driver (built-in, not a module).
>
> Now, on boot, I get the crash below. I'm not too sure how to debug
> this (is there an equivalent ksymoops tool for ARM crashes that will
> run on my x86 platform?)
--
Ben Greear <[EMAIL PROTECTED]> <Ben_Greear AT excite.com>
President of Candela Technologies Inc http://www.candelatech.com
ScryMUD: http://scry.wanfear.com http://scry.wanfear.com/~greear
_______________________________________________
http://lists.arm.linux.org.uk/mailman/listinfo/linux-arm
http://www.arm.linux.org.uk/armlinux/mailinglists.php
Please visit the above addresses for information on this list.
