I've gotten 2.3.18-rmk1-cvs991006 to boot on my hardware, but there's
a problem with the PDC20262 support --
Uniform Multi-Platform E-IDE driver Revision: 6.20
PDC20262: IDE controller on PCI bus 00 dev a0
PDC20262: not 100% native mode: will probe irqs later
PDC20262: ROM enabled at 0x02400000
PDC20262: (U)DMA Burst Bit DISABLED Primary PCI Mode Secondary PCI Mode.
PDC20262: neither IDE port enabled (BIOS)
leading, of course, to
VFS: Cannot open root device 03:01
Kernel panic: VFS: Unable to mount root fs on 03:01
The 'neither IDE port enabled' bit surprises me; it boots fine under
2.2.7 and 2.2.12, so clearly some port has to be active.
Can anyone shed any light on this?
For a little extra info, this is on a modified EBSA285 board, and my
kernels are cross-compiled from a gcc-2.95.1/binutils-2.9.5.0.14
toolchain that I've built.
Neither 2.3.19-rmk1 nor 2.3.18-rmk2 boots on this machine, btw.
--nat
--
nat lanza --------------------- research programmer, parallel data lab, cmu scs
[EMAIL PROTECTED] -------------------------------- http://www.cs.cmu.edu/~magus/
there are no whole truths; all truths are half-truths -- alfred north whitehead
unsubscribe: body of `unsubscribe linux-arm' to [EMAIL PROTECTED]
