Hai all, Presently I'm working with cirrus logic cl-ps7500fe Arm processor evaluation board.I'm trying to port linux onto it and mounting the filesystem using NFS. I've the kernal compiled.I've got it from net. When I port the kernal to my target using Angelboot,the (error)messages that are displayed are as followes, (After running some of the kernal parts,when it comes for ethernet section..) -------------------------------------------------------------------- eth0: cs8900 rev J found at 0x80090300 cs89x0: Extended EEPROM checksum bad and no cirrus EEPROM, relying on command le cs89x0 media IRQ 12,Programmed I/O, MAC 00:00:00:00:00:00 .... ( some serial port config..) .... eth0: EEPROM is configured for unavailable media .. ... --------------------------------------------------------------------- (It keeps going untill RFC error comes) Does this means the EEPROM is not configured or some other problem?!! I even tried with a 93c46 prom which was there in a networkcard of other manufacturer.can I do this? Does these EEPROMs require special configuration for cs8900 chip?. If anybody knows something in this regard, pl. let me know where I'm making mistake,and what I can do to get rid of this. Thanks, With best regards, J.SARAVANAN unsubscribe: body of `unsubscribe linux-arm' to [EMAIL PROTECTED] ++ Please use [EMAIL PROTECTED] for ++ ++ kernel-related discussions. ++
