Marek, This is the agent I wrote. I have not done a man page or perldoc for it, but it is documented in the comments.
Regards, Erik Dorthé NOC Engineer CARI.net 858.974.5080 x217 [email protected] <http://www.cari.net/> On Mon, Feb 11, 2013 at 10:23 AM, Marek Grac <[email protected]> wrote: > On 02/11/2013 05:36 PM, Erik Dorthe wrote: > >> I know there has been an agent submitted for this before (see link at the >> bottom of this email), but I created an agent for the Tripp Lite SNMP >> Management Card. This agent uses SNMP to issue commands to a Tripp Lite >> PDU. I have found that some of the limitations mentioned in the past do not >> seem to exist anymore, which may be a result of a firmware update (I am >> using version 12.06.0061). >> >> The primary limitation was a delay in the power state change, which had >> taken up to 35 seconds in the past. I have found no delay over 10 seconds, >> which improves response time significantly. >> >> I have put this agent into testing in a prototype cluster, and my initial >> results look good. The model I am testing with is a PDUMH20ATNET. If anyone >> would like to look over the agent or review it for inclusion, please >> contact me. >> > Sure, please resend agent to me > > m, > > -- > Linux-cluster mailing list > [email protected] > https://www.redhat.com/**mailman/listinfo/linux-cluster<https://www.redhat.com/mailman/listinfo/linux-cluster> >
fence_tripplite_snmp
Description: Binary data
-- Linux-cluster mailing list [email protected] https://www.redhat.com/mailman/listinfo/linux-cluster
