The Atmel ECC driver contains a check for the I2C bus clock frequency, so as to check that the I2C adapter in use satisfies the device specs.
If the device is connected to a device tree node that does not contain a clock frequency setting, such as an I2C mux or gate, this blocks the probe. Make the probe continue silently if no clock frequency can be found, assuming all is safe. Signed-off-by: Linus Walleij <linus.wall...@linaro.org> --- drivers/crypto/atmel-ecc.c | 11 +++++------ 1 file changed, 5 insertions(+), 6 deletions(-) diff --git a/drivers/crypto/atmel-ecc.c b/drivers/crypto/atmel-ecc.c index e66f18a0ddd0..145ab3a39a56 100644 --- a/drivers/crypto/atmel-ecc.c +++ b/drivers/crypto/atmel-ecc.c @@ -657,14 +657,13 @@ static int atmel_ecc_probe(struct i2c_client *client, return -ENODEV; } + /* + * Silently assume all is fine if there is no + * "clock-frequency" property. + */ ret = of_property_read_u32(client->adapter->dev.of_node, "clock-frequency", &bus_clk_rate); - if (ret) { - dev_err(dev, "of: failed to read clock-frequency property\n"); - return ret; - } - - if (bus_clk_rate > 1000000L) { + if (!ret && (bus_clk_rate > 1000000L)) { dev_err(dev, "%d exceeds maximum supported clock frequency (1MHz)\n", bus_clk_rate); return -EINVAL; -- 2.17.0