The following is my diald.conf:
mode ppp
connect "/usr/sbin/chat -f /etc/ppp/dial-on"
device /dev/ttyS1
speed 115200
modem
lock
crtscts
local 127.0.0.4
remote 127.0.0.5
defaultroute
include /usr/lib/diald/standard.filter
This is my "dial-on" file used by "diald.conf":
#!/bin/sh
echo "DIALING"
echo
DEVICE=cua1
SPEED=115200
/usr/sbin/pppd $DEVICE $SPEED file /etc/ppp/options
/etc/ppp/set-route
This is the "options" file that "dial-on" uses:
connect "/usr/sbin/chat -t 60 -f /etc/ppp/script"
netmask 255.255.255.0
crtscts
defaultroute
asyncmap 0
name talmonnm
and this is "script" used by "options":
ABORT BUSY ABORT "NO CARRIER" "" ATZ OK ATDT9,5166222 CONNECT ""
What am I missing?
Paul wrote:
> Diald brings up the ppp interface when an outside address is requested.
> Diald monitors the sl0 interface you see in the routing table.
> Check your diald.conf file to make sure you have the "mode" option set to ppp
> and that other settings are correct. The Diald man pages do a pretty goood
> job of giving examples of this file. Do a man on "diald-examples".
>
> Good luck
>
> Talmon Reiss wrote:
>
> > I have installed diald on a Slackware 2.0.33 distribution. The sl0
> > interface is up and there is default route through this interface.
> > However the pppd does not start when it is needed ie. when a connection
> > request comes along. So my question is: what invokes the pppd when a
> > connection is required?
> >
> > Talmon
> >
-
To unsubscribe from this list: send the line "unsubscribe linux-diald" in
the body of a message to [EMAIL PROTECTED]
