Hi,
I'm trying to setup diald using regular ethernet-cards
(I have an isdn-router connected to a linux-box which
acts as firewall/proxy).
On the side of the router I have eth1, which I would
like to bring up and down using diald.
On the other side I have eth0 which is the connection
to the internal network.
However, this does not seem to work... I specified --
in diald.conf -- that diald should use eth1 (mode dev)
but when it should bring up a link it uses eth0
instead of eth1 -- with the following message:
diald[PID]: Old eth1 , New device : eth 0
Is it possible to use diald to control ethernet-cards
(not isdn-ethernet, as the isdn4linux people use)?
If not, is there an alternative?
If yes: how do I get it to work?
Thanks for any info,
bt
__________________________________________________
Do You Yahoo!?
Bid and sell for free at http://auctions.yahoo.com
-
To unsubscribe from this list: send the line "unsubscribe linux-diald" in
the body of a message to [EMAIL PROTECTED]
