On 03/10/2018 12:32, Paul Cercueil wrote: > > Le 1 oct. 2018 10:48, Daniel Lezcano <daniel.lezc...@linaro.org> a > écrit : >> >> On 31/07/2018 00:01, Paul Cercueil wrote: >> >> [ ... ] >> >>>>> +- ingenic,timer-channel: Specifies the TCU channel that >>>>> should be used as + system timer. If not provided, the TCU >>>>> channel 0 is used for the system timer. + +- >>>>> ingenic,clocksource-channel: Specifies the TCU channel that >>>>> should be used + as clocksource and sched_clock. It must be >>>>> a different channel than the one + used as system timer. If >>>>> not provided, neither a clocksource nor a + sched_clock is >>>>> instantiated. >>>> >>>> clocksource and sched_clock are Linux specific and don't belong >>>> in DT. You should define properties of the hardware or use >>>> existing properties like interrupts or clocks to figure out >>>> which channel to use. For example, if some channels don't have >>>> an interrupt, then use them for clocksource and not a >>>> clockevent. Or you could have timers that run in low-power >>>> modes or not. If all the channels are identical, then it >>>> shouldn't matter which ones the OS picks. >> >> It can't work in this case because the pmw and the timer driver are >> not communicating and the first one can stole a channel to the last >> one. > > In that particular case the timer driver will always request its > channels first; with no timer set the system hangs before > subsys_initcall, and the PWM driver is a subnode of the timer node, > so is probed only after the timer probed. > >>> We already talked about that. All the TCU channels can be used >>> for PWM. The problem is I cannot know from the driver's scope >>> which channels will be free and which channels will be requested >>> for PWM. You suggested that I parse the devicetree for clients, >>> and I did that in the V3/V4 patchset. But it only works for >>> clients requesting through devicetree, not from platform code or >>> even sysfs. >>> >>> One thing I can try is to dynamically change the channels the >>> system timer and clocksource are using when the current ones are >>> requested for PWM. But that sounds hardcore... >> >> Yes, it is :/ >> >> Sorry for letting you wasting time and effort to write an overkill >> code not suitable for upstream. >> >> A very gross thought, wouldn't be possible to "register" a channel >> from the timer driver code in a shared data area (but well >> self-encapsulated) and the pwm code will check such channel isn't >> in use ? > > Probably, but it's the contrary I need to do. The timer driver code > can use any channel, and probes first. The PWM driver code must use > specific channels, and probes last. So either the timer driver knows > what channels it can't use, thanks to a device property, or it adapts > itself when a channel in use is requested for PWM, which is what I > tried in v7.
When you say "must use specific channels", where is coming this information ? > I think we could find a way to use a devicetree property that doesn't > trigger Rob. That would still be the easiest and cleanest solution. > > Maybe "ingenic,reserved-channels-mask", which would contain a mask of > channels that can only be used by the timer driver. And what the > timer driver does with these channels, would be specific to the > implementation and would not appear in the bindings. I hope Rob can > work with that. > > -Paul > -- <http://www.linaro.org/> Linaro.org │ Open source software for ARM SoCs Follow Linaro: <http://www.facebook.com/pages/Linaro> Facebook | <http://twitter.com/#!/linaroorg> Twitter | <http://www.linaro.org/linaro-blog/> Blog