the same thing occured to me some time ago. Just a very weak signal coming from the composite output, same on J2. However, the SVHS output still worked, using vidmode=2. Pin 5 should at least give a black/white picture when connected to a composite input. Are you sure you hooked up your tv in the right way?
Ruurd. --- Matthias Queisler <[EMAIL PROTECTED]> wrote: > hey again list, > > I reported that the composite output of my DVBs 1.3 is broken. I don't get > any video signal, only audio is present. Now I build a little connector for > the J2 like described on > http://www.lindy.cc/local/LinuxDVB.nsf/e95ed8396fac68cfc1256a010064762b/f50a > 46f693a7e5b6c1256a0300654f91?OpenDocument . I choosed the SVHS version on > the left, because I just wanted to test, if I still get a signal over the > J2. I was ready and connected the VDR to my TV. And "surprise", I get a > video signal. But the picture is only black/white and is flickering. It's > like a not well tuned channel on cable or "terrestisch". > Is it possible, that it is my fault, that the picture is like described? Or > does this mean my card is gone? Ok, I can still use it as secondary > interface. My only problem with the DVBs 2.1 is, that I don't have a > connector for the mini DIN so I ca not use it as primary interface. > Any suggestions on how to connect the DVBs 2.1 to the TV or how to fix my > DVBs 1.3? > > greetz and thx, > > Matthias Queisler > > > > -- > Info: > To unsubscribe send a mail to [EMAIL PROTECTED] with "unsubscribe linux-dvb" > as subject. > __________________________________________________ Do You Yahoo!? Yahoo! Tax Center - online filing with TurboTax http://taxes.yahoo.com/ -- Info: To unsubscribe send a mail to [EMAIL PROTECTED] with "unsubscribe linux-dvb" as subject.
