maroi wrote: > > maybe it will help you if I paste my dmesg messages of modprobe dvb > i2c-core.o: i2c core module > i2c-core.o: i2c core module > PCI: Found IRQ 12 for device 00:0a.0 > saa7146_core: saa7146 #0 @ pci 00:0a.0; rev=1; mem=0xe6002000; irq=12; > subsys=0x13c2,0x0000. > saa7146_core: saa7146 #0: using 2 capture buffers of 1728 KBytes each (3456 > KBytes total) > saa7146_core: saa7146 #0: latency=32 clks; threshold=32 dwrds; burst=128 > dwrds. > saa7146_core: 1 SAA7146 chipset(s) found. > saa7146_core: extension 0 registered: "v4l extension" > Linux video capture interface: v1.00 > dvb.o Technotrend/Siemens DVB driver version 0.8.2 patch 9f > dvb0: ambiguous subsystem id (0x13c2,0x0000) on saa7146 #0. ^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^ This is a potential issue. There have been some problems with subsystem id's and skystar1 cards and the detection code Rolf wrote. With patch 8, it didn't detect my card. I had to manually patch the driver, run a modified version of dumpee then recompile the original driver in order to make it work. I talked to Rolf about this and probably this message is the result (as he modified the code not to halt loading in case of unknown id's)
A more detalied description of this is on my webpage http://members.tripod.com/andrei_b/linux (look for the dvb drivers section). > dvb0: probing for I2C client VES1893 @ 0x08... found. > dvb0: DVB-S Rev. 1.3 auto-detected on saa7146 #0. > sp5659.o i2c driver > sp5659: MITEL SP5659 #0 detected at i2c address 0x61. > sp5659: MITEL SP5659 #0 @ 0x61 attached to adapter saa7146 #0. > ves1893.o i2c driver > ves1893: VLSI VES1893 #0 detected at i2c address 0x08. > ves1893: VLSI VES1893 #0 @ 0x08 attached to adapter saa7146 #0. > ee24lc16.o i2c driver > ee24lc16: Serial EEPROM #0 detected at i2c address 0x50. > ee24lc16: Serial EEPROM #0 @ 0x50 attached to adapter saa7146 #0. > dvb0: V4L video device registered on (81, 0). > dvb0: V4L vbi device registered on (81, 224). > dvb0: ARM firmware successfully loaded. > dvb0: firmware = f0240009 > dvb0: MAC = 00 XX XX 00 XX XX > saa7146_core: extension 1 registered: "dvb extension" > dvb: 1 dvb(s) found! The rest look good. ( a load error would most likely yield "dvb: 0 dvb(s) found!" ) -- ing. Andrei Boros mailto:andrei@;srr.ro / +40-1-303-1870 Centrul pt. Tehnologia Informatiei Societatea Romana de Radiodifuziune -- Info: To unsubscribe send a mail to [EMAIL PROTECTED] with "unsubscribe linux-dvb" as subject.
