Question for the Hauppauge WinTV DVB-S gurus.
At least with version linuxtv-dvb-1.0.0-pre2 when I add a
network interface via dvbnet the MAC address is not populated.
net_start.pl makes a call to set the hw ether addr, versus
reading it off the card.
That being said, I notice that the card has an ATMEL AT24C16N
serial EEPROM. I guess it would be a huge coincidence if this
EEPROM has hanging off the I2C bus and that I could grab the
MAC address via stv0299_readreg(), an existing routine for the
frontend chip on this board. If so, maybe someone would even
know the address location of the MAC? I haven't been able to
get through to Hauppauge on this EEPROM.
Michael Glaum
KVH Industries
--
Info:
To unsubscribe send a mail to [EMAIL PROTECTED] with "unsubscribe linux-dvb" as
subject.
