Klaus Schmidinger wrote: > Andrew de Quincey wrote: > > > > I get you, its the 'v'. Previously the driver was turning voltage on when it > > started up, so power was being supplied, whereas now by default leaves it > > off. > > So this means VDR should turn the voltage _on_ upon startup, right? > I don't think having to do this via the DiSEqC configuration is the > way to go...
Hm, it's been a while since I read the DiSEqC spec, but IIRC the sequence is: - turn off 22KHz - set voltage to 13V or 18V - send DiSEqC sequence - if necessary turn on 22KHz It doesn't make much sense to remove the power from the LNB while sending the DiSEqC sequence, but luckily vdr doesn't seem to do that ;-) So, I guess that 'v' is a no-op. There are some mandatory delays before and after sending the DiSEqC sequence. The Nokia API rolled all that in a simple and convenient ioctl which would allow the driver to do all the timing (so that applications cannot fuck up), but Holger removed it. Johannes -- Info: To unsubscribe send a mail to [EMAIL PROTECTED] with "unsubscribe linux-dvb" as subject.
