Sorry for the duplicate, I had some smtp problems and thought the first message 
was "gone" instead it was hiding.

_J

>>> Jeremy Hall<[EMAIL PROTECTED]> 10/4/2007 9:50:41 AM >>>
Hello,

I am trying to write an application that attempts to find the symbol rate of a 
QPSK carrier by making an intelligent guess as to the likely symbol rate, 
followed by a brute-force method of starting at the suggested value and 
incrementing or decrementing from that value by 1000, gradually making the 
distance from the starting point larger and larger in both directions.

the problem

I have set inversion to auto, FEC to auto, and the frequency to the correct 
value for the carrier.  I want the driver to scan the values I provide within a 
1khz tolerence for all FEC choices and both spectral inversions. I don't know 
how long that takes but I'd like it for obvious reasons to go as quickly as 
possible.  Since I don't know how long this takes, I decided to sleep for a few 
seconds then read status to determine if FE_HAS_LOCK so I can stop.

To my horror, I discovered, by running dvbsnoop -s feinfo in another window, 
that not only were my symbol rates different than my suggested values, but the 
frequency was different as well.  In fact, I noticed that if you wait long 
enough, you can lock onto a neighbouring signal that isn't even the one you 
wanted, and the frequency reported is something in the middle but closer to 
what you want, yet clearly it is the other signal, for example, two DSNG 
carriers are located at 12116 and 12121 respectively, with a symbol rate of 
3979.  At first I thought my LO was wrong, but try to lock the first one, wait 
about 8 seconds and then the second one magically locks even though I didn't 
want that one.

I think it's reasonable to say your frequency could be off as much as 1khz in 
either direction, or at least a module parameter should be enstantiated so you 
can tell the driver you were to cheap to buy a decent LNB.  So how do I get 
what I want? I think the driver probably could do what I want in under a second 
as long as te symbol rate is not super low like 1000.  I am using the stv0299 
frontend.

_J

_______________________________________________
linux-dvb mailing list
[email protected] 
http://www.linuxtv.org/cgi-bin/mailman/listinfo/linux-dvb

_______________________________________________
linux-dvb mailing list
[email protected]
http://www.linuxtv.org/cgi-bin/mailman/listinfo/linux-dvb

Reply via email to