Hello Mr Lange,
Well I do the installation by network.
How I proceed to install the non free firmware in the initrd of FAI?
Kind regards,
---------------------------------------
Bruno FERREIRA PINTO
Service Informatique
IJCLab
IN2P3/CNRS
Universite Paris-Sud 11
Rue André Ampere Bt 100A Pce A118
91898 Orsay Cédex
---------------------------------------
----- Mail original -----
De: "Thomas Lange" <la...@cs.uni-koeln.de>
À: "fully automatic installation for Linux" <linux-fai@uni-koeln.de>
Envoyé: Lundi 11 Juillet 2022 15:57:40
Objet: Re: Dracut : Could not boot
>>>>> On Mon, 11 Jul 2022 15:02:26 +0200 (CEST), bruno pinto
>>>>> <pi...@lal.in2p3.fr> said:
> Last friday, I receive a new laptop to install by FAI (Dell Precision
5570) , and when I boot by PXE with FAI, I have a message lie this:
Do you do a network installation with FAI? Or do you boot a FAI ISO
from USB/CD,....?
> "dracut: Warning: could not boot"
This may be because of an unknown hardware device. If you do the
network installation, the ethernet device must be activated. Otherwise
the USB device containing the ISO will be used.
Maybe your ethernet device needs some nonfree firmware, which is not
included into the initrd that dracut is using.
Do you have any more detailed warning/error message?
--
regards Thomas
