Hello, I have been using fai for some time already. Installing centos 7 and debian 9 without any major issues. Problem came up when I tried to run Centos 6.
Does anyone from the list successfully performed installation of Centos6 with fai recently? Tried reinstalling fai server completely with config taken from examples. I run server on Debian 9 distribution. Most noticeable failure i get from shell.log: CENTOS/30-mkinitrd FAILED with exit code 1. ===== shell: CENTOS/40-install-grub ===== GNU GRUB version 0.97 (640K lower / 3072K upper memory) [ Minimal BASH-like line editing is supported. For the first word, TAB lists possible command completions. Anywhere else TAB lists the possible completions of a device/filename.] grub> device (hd0) /dev/sda grub> root (hd0,0) Filesystem type is ext2fs, partition type 0x83 grub> setup (hd0) Checking if "/boot/grub/stage1" exists... no Checking if "/grub/stage1" exists... no Error 14t: Filesystem compatibility error, cannot read whole file grub> quit Grub installed on /dev/sda = (hd0) Grub boot partition is /dev/sda1 = (hd0,0) Root partition is LABEL=ROOT Boot kernel: 2.6.32-754.2.1.el6.x86_64 It looks like grub does not recognise ext4 fs. I don't get this error if I set ext3 in disk_config, but I would like to use ext4. My disk layout: disk_config disk1 disklabel:msdos bootable:1 fstabkey:label primary / 4G-50G ext4 rw,noatime,errors=remount-ro createopts="-L ROOT" logical swap 200-10G swap sw createopts="-L SWAP" logical /tmp 100-5G ext4 rw,noatime,nosuid,nodev createopts="-L TMP -m 0" tuneopts="-c 0 -i 0" logical /home 100- ext4 rw,noatime,nosuid,nodev createopts="-L HOME -m 1" tuneopts="-c 0 -i 0" My soft version: p dracut 047+31-1 p dracut-config-generic 047+31-1 p dracut-config-rescue 047+31-1 p dracut-core 047+31-1 p dracut-core-dbgsym 047+31-1 p dracut-network 047+31-1 i fai-client 5.7 i fai-doc 5.7 p fai-nfsroot 5.7 i fai-quickstart 5.7 i fai-server 5.7 p fai-setup-storage 5.7 Would appreciate your response. best regards, Antanas