On Mon, Nov 20, 2017 at 03:12:06PM +1030, Andrew Jeffery wrote:
> The dual tachometer feature is implemented in hardware with a TACHSEL
> input to indicate the rotor under measurement, and exposed on the device
> by extending the READ_FAN_SPEED_1 word with two extra bytes*. The need
> to read the non-standard four-byte response leads to a cut-down
> implementation of i2c_smbus_xfer_emulated() included in the driver.
> Further, to expose the second rotor tachometer value to userspace the
> values are exposed through virtual pages. We re-route accesses to
> FAN_CONFIG_1_2 and READ_FAN_SPEED_1 on pages 23-28 (not defined by the
> hardware) to the same registers on pages 0-5, and with the latter command
> we extract the value from the second word of the four-byte response.
>
> * The documentation recommends the slower rotor be associated with
> TACHSEL=0, which corresponds to the first word of the response. The
> TACHSEL=0 measurement is used by the controller's closed-loop fan
> management to judge target fan rate.
>
> Signed-off-by: Andrew Jeffery <and...@aj.id.au>
Applied.
Thanks,
Guenter
> ---
> Documentation/hwmon/max31785 | 8 +-
> drivers/hwmon/pmbus/max31785.c | 147 ++++++++++++++++++++++++++++++++++-
> 2 files changed, 152 insertions(+), 3 deletions(-)
>
> diff --git a/Documentation/hwmon/max31785 b/Documentation/hwmon/max31785
> index 7b0a0a8cdb6b..270c5f865261 100644
> --- a/Documentation/hwmon/max31785
> +++ b/Documentation/hwmon/max31785
> @@ -17,8 +17,9 @@ management with temperature and remote voltage sensing.
> Various fan control
> features are provided, including PWM frequency control, temperature
> hysteresis,
> dual tachometer measurements, and fan health monitoring.
>
> -For dual rotor fan configuration, the MAX31785 exposes the slowest rotor of
> the
> -two in the fan[1-4]_input attributes.
> +For dual-rotor configurations the MAX31785A exposes the second rotor
> tachometer
> +readings in attributes fan[5-8]_input. By contrast the MAX31785 only exposes
> +the slowest rotor measurement, and does so in the fan[1-4]_input attributes.
>
> Usage Notes
> -----------
> @@ -31,7 +32,8 @@ Sysfs attributes
>
> fan[1-4]_alarm Fan alarm.
> fan[1-4]_fault Fan fault.
> -fan[1-4]_input Fan RPM.
> +fan[1-8]_input Fan RPM. On the MAX31785A, inputs 5-8
> correspond to the
> + second rotor of fans 1-4
> fan[1-4]_target Fan input target
>
> in[1-6]_crit Critical maximum output voltage
> diff --git a/drivers/hwmon/pmbus/max31785.c b/drivers/hwmon/pmbus/max31785.c
> index 8706a696c89a..bffab449be39 100644
> --- a/drivers/hwmon/pmbus/max31785.c
> +++ b/drivers/hwmon/pmbus/max31785.c
> @@ -16,9 +16,79 @@
>
> enum max31785_regs {
> MFR_REVISION = 0x9b,
> + MFR_FAN_CONFIG = 0xf1,
> };
>
> +#define MAX31785 0x3030
> +#define MAX31785A 0x3040
> +
> +#define MFR_FAN_CONFIG_DUAL_TACH BIT(12)
> +
> #define MAX31785_NR_PAGES 23
> +#define MAX31785_NR_FAN_PAGES 6
> +
> +static int max31785_read_byte_data(struct i2c_client *client, int page,
> + int reg)
> +{
> + if (page < MAX31785_NR_PAGES)
> + return -ENODATA;
> +
> + switch (reg) {
> + case PMBUS_VOUT_MODE:
> + return -ENOTSUPP;
> + case PMBUS_FAN_CONFIG_12:
> + return pmbus_read_byte_data(client, page - MAX31785_NR_PAGES,
> + reg);
> + }
> +
> + return -ENODATA;
> +}
> +
> +static int max31785_write_byte(struct i2c_client *client, int page, u8 value)
> +{
> + if (page < MAX31785_NR_PAGES)
> + return -ENODATA;
> +
> + return -ENOTSUPP;
> +}
> +
> +static int max31785_read_long_data(struct i2c_client *client, int page,
> + int reg, u32 *data)
> +{
> + unsigned char cmdbuf[1];
> + unsigned char rspbuf[4];
> + int rc;
> +
> + struct i2c_msg msg[2] = {
> + {
> + .addr = client->addr,
> + .flags = 0,
> + .len = sizeof(cmdbuf),
> + .buf = cmdbuf,
> + },
> + {
> + .addr = client->addr,
> + .flags = I2C_M_RD,
> + .len = sizeof(rspbuf),
> + .buf = rspbuf,
> + },
> + };
> +
> + cmdbuf[0] = reg;
> +
> + rc = pmbus_set_page(client, page);
> + if (rc < 0)
> + return rc;
> +
> + rc = i2c_transfer(client->adapter, msg, ARRAY_SIZE(msg));
> + if (rc < 0)
> + return rc;
> +
> + *data = (rspbuf[0] << (0 * 8)) | (rspbuf[1] << (1 * 8)) |
> + (rspbuf[2] << (2 * 8)) | (rspbuf[3] << (3 * 8));
> +
> + return rc;
> +}
>
> static int max31785_get_pwm(struct i2c_client *client, int page)
> {
> @@ -62,9 +132,30 @@ static int max31785_get_pwm_mode(struct i2c_client
> *client, int page)
> static int max31785_read_word_data(struct i2c_client *client, int page,
> int reg)
> {
> + u32 val;
> int rv;
>
> switch (reg) {
> + case PMBUS_READ_FAN_SPEED_1:
> + if (page < MAX31785_NR_PAGES)
> + return -ENODATA;
> +
> + rv = max31785_read_long_data(client, page - MAX31785_NR_PAGES,
> + reg, &val);
> + if (rv < 0)
> + return rv;
> +
> + rv = (val >> 16) & 0xffff;
> + break;
> + case PMBUS_FAN_COMMAND_1:
> + /*
> + * PMBUS_FAN_COMMAND_x is probed to judge whether or not to
> + * expose fan control registers.
> + *
> + * Don't expose fan_target attribute for virtual pages.
> + */
> + rv = (page >= MAX31785_NR_PAGES) ? -ENOTSUPP : -ENODATA;
> + break;
> case PMBUS_VIRT_PWM_1:
> rv = max31785_get_pwm(client, page);
> break;
> @@ -157,11 +248,15 @@ static int max31785_write_word_data(struct i2c_client
> *client, int page,
> #define MAX31785_VOUT_FUNCS \
> (PMBUS_HAVE_VOUT | PMBUS_HAVE_STATUS_VOUT)
>
> +#define MAX37185_NUM_FAN_PAGES 6
> +
> static const struct pmbus_driver_info max31785_info = {
> .pages = MAX31785_NR_PAGES,
>
> .write_word_data = max31785_write_word_data,
> + .read_byte_data = max31785_read_byte_data,
> .read_word_data = max31785_read_word_data,
> + .write_byte = max31785_write_byte,
>
> /* RPM */
> .format[PSC_FAN] = direct,
> @@ -208,13 +303,46 @@ static const struct pmbus_driver_info max31785_info = {
> .func[22] = MAX31785_VOUT_FUNCS,
> };
>
> +static int max31785_configure_dual_tach(struct i2c_client *client,
> + struct pmbus_driver_info *info)
> +{
> + int ret;
> + int i;
> +
> + for (i = 0; i < MAX31785_NR_FAN_PAGES; i++) {
> + ret = i2c_smbus_write_byte_data(client, PMBUS_PAGE, i);
> + if (ret < 0)
> + return ret;
> +
> + ret = i2c_smbus_read_word_data(client, MFR_FAN_CONFIG);
> + if (ret < 0)
> + return ret;
> +
> + if (ret & MFR_FAN_CONFIG_DUAL_TACH) {
> + int virtual = MAX31785_NR_PAGES + i;
> +
> + info->pages = virtual + 1;
> + info->func[virtual] |= PMBUS_HAVE_FAN12;
> + info->func[virtual] |= PMBUS_PAGE_VIRTUAL;
> + }
> + }
> +
> + return 0;
> +}
> +
> static int max31785_probe(struct i2c_client *client,
> const struct i2c_device_id *id)
> {
> struct device *dev = &client->dev;
> struct pmbus_driver_info *info;
> + bool dual_tach = false;
> s64 ret;
>
> + if (!i2c_check_functionality(client->adapter,
> + I2C_FUNC_SMBUS_BYTE_DATA |
> + I2C_FUNC_SMBUS_WORD_DATA))
> + return -ENODEV;
> +
> info = devm_kzalloc(dev, sizeof(struct pmbus_driver_info), GFP_KERNEL);
> if (!info)
> return -ENOMEM;
> @@ -225,6 +353,25 @@ static int max31785_probe(struct i2c_client *client,
> if (ret < 0)
> return ret;
>
> + ret = i2c_smbus_read_word_data(client, MFR_REVISION);
> + if (ret < 0)
> + return ret;
> +
> + if (ret == MAX31785A) {
> + dual_tach = true;
> + } else if (ret == MAX31785) {
> + if (!strcmp("max31785a", id->name))
> + dev_warn(dev, "Expected max3175a, found max31785:
> cannot provide secondary tachometer readings\n");
> + } else {
> + return -ENODEV;
> + }
> +
> + if (dual_tach) {
> + ret = max31785_configure_dual_tach(client, info);
> + if (ret < 0)
> + return ret;
> + }
> +
> return pmbus_do_probe(client, id, info);
> }
>
--
To unsubscribe from this list: send the line "unsubscribe linux-hwmon" in
the body of a message to majord...@vger.kernel.org
More majordomo info at http://vger.kernel.org/majordomo-info.html
