On 5/30/19 1:29 AM, Andrew Lunn wrote: > On Tue, May 28, 2019 at 11:33:33PM +0200, Marek Vasut wrote: >> On 5/28/19 11:22 PM, Andrew Lunn wrote: >>>> The link detection on the TJA1100 (not TJA1101) seems unstable at best, >>>> so I better use all the interrupt sources to nudge the PHY subsystem and >>>> have it check the link change. >>> >>> Then it sounds like you should just ignore interrupts and stay will >>> polling for the TJA1100. >> >> Polling for the link status change is slow(er) than the IRQ driven >> operation, so I would much rather use the interrupts. > > I agree about the speed, but it seems like interrupts on this PHY are > not so reliable. Polling always works. But unfortunately, you cannot > have both interrupts and polling to fix up problems when interrupts > fail. Your call, do you think interrupts really do work?
It works fine for me this way. And mind you, it's only the TJA1100 that's flaky, the TJA1101 is better. > If you say that tja1101 works as expected, then please just use the > link up/down bits for it. I still don't know which bits really trigger link status changes, so I'd like to play it safe and just trigger on all of them. -- Best regards, Marek Vasut